If you have a Whirlpool microwave oven, you know how convenient it is to cook and reheat your food in minutes. But what if your microwave door handle breaks or cracks? You don’t want to struggle with opening and closing the door every time you use your microwave, right?
To replace a Whirlpool microwave door handle, you need to remove the grill, the door panel, and the old handle. Then, you need to install the new handle and reassemble the door and the grill.
Don’t worry, replacing a Whirlpool microwave door handle is not as hard as it sounds. In fact, you can do it yourself with some basic tools and a little bit of patience. In this post, we will show you how to replace a Whirlpool microwave door handle in 7 easy steps. Let’s get started!
Before you begin, make sure you have the following tools and materials:
The first and most important step is to disconnect the microwave from its power source. You don’t want to risk getting electrocuted or damaging your microwave while working on it. Simply unplug the microwave from the wall outlet or turn off the circuit breaker that controls it.
The next step is to remove the grill that covers the top of the microwave. This will give you access to the screws that hold the door in place. To remove the grill, unthread the screws that secure it with a Phillips screwdriver. Then, slide the grill to the left and lift it off.
Now, you need to remove the inner panel of the door that covers the handle screws. To do this, open the microwave door and make sure you have clear access to the inner panel. Then, use a flat-head screwdriver or a putty knife to depress the retaining tabs that hold the panel in place. Be careful not to damage the panel or the tabs. Once you release all the tabs, lift off the panel and set it aside.
You are now ready to remove the old handle from the door. Using a T10 Torx bit screwdriver, remove the screws that hold the handle in place. There should be two screws on each side of the handle. Once you remove all four screws, pull out the old handle and discard it.
Now that you have removed the old handle, you can install the new one. Align the new handle with the holes on the door and insert it into place. Then, secure it with the screws that you removed earlier using a T10 Torx bit screwdriver. Make sure to tighten them firmly but not too much.
The next step is to reinstall the inner panel of the door that you removed earlier. Align it with the door and snap it into place by pushing on it until you hear a click. Make sure all the tabs are locked in and there are no gaps between the panel and the door.
the Grill
The final step is to reinstall the grill that covers the top of the microwave. Align it with the slots on the microwave and slide it to the right. Then, secure it with the screws that you removed earlier using a Phillips screwdriver. Make sure to tighten them firmly but not too much.
You have successfully replaced your Whirlpool microwave door handle! Now you can enjoy using your microwave without any hassle. Just remember to reconnect your microwave to its power source before using it.
We hope this post was helpful and informative for you. If you have any questions or comments, feel free to leave them below. And if you liked this post, please share it with your friends and family who might need some help with their microwaves.
Thank you for reading Presstocook.com, your online source for cooking tips and tricks!
