How To Replace The Led Light In A Whirlpool Freezer

If you have a Whirlpool freezer that has a LED light inside, you might need to replace it if it burns out or stops working. Replacing the LED light in a Whirlpool freezer is not very difficult and can be done in a few minutes. In this post, we will show you how to replace the LED light in a Whirlpool freezer with a few simple steps.

To replace the LED light in a Whirlpool freezer, you need to unplug the freezer, remove the light shield, disconnect the wires, replace the LED module, reconnect the wires, and reinstall the light shield.

Why You Might Need To Replace The LED Light In Your Freezer

The LED light in your Whirlpool freezer is designed to last for a long time and provide bright and energy-efficient illumination for your frozen food. However, sometimes the LED light might fail or malfunction due to various reasons, such as:

• Power surges or fluctuations
• Faulty wiring or connections
• Damage or wear and tear
• Defective or incompatible LED module

If your LED light is not working properly or at all, you might need to replace it with a new one. You can purchase a replacement LED module from an authorized dealer or online. Make sure you get the right part number and model for your freezer.

How To Replace The LED Light In Your Whirlpool Freezer

Replacing the LED light in your Whirlpool freezer is easy and quick. You just need to follow these steps:

1. Unplug the freezer from the wall outlet. This will prevent any electric shock or damage to the freezer or the LED module.
2. Remove the light shield by squeezing the lens from the sides, pushing back and pulling down. The light shield is the plastic cover that protects the LED module from dust and moisture.
3. Disconnect the wires that connect the LED module to the freezer. You might need to use a small screwdriver or a needle-nose pliers to pry off the plastic caps that secure the wires to the terminals.
4. Replace the LED module with a new one. Make sure you align the pins on the module with the holes on the freezer. Push it firmly into place until it snaps.
5. Reconnect the wires to the terminals on the LED module. Make sure you match the colors and polarity of the wires. Put back the plastic caps that secure the wires.
6. Reinstall the light shield by aligning it with the slots on the freezer and pushing it up until it locks.
7. Plug in the freezer and check if the LED light works properly.

FAQs

• How do I know if my Whirlpool freezer has a LED light or not?

You can check if your Whirlpool freezer has a LED light or not by looking at the model number of your freezer. If your model number starts with WRF, WZF, EVL, EVN, EVU, EVH, EVD, EVF, EVS, or EVR, then your freezer has a LED light.

• How do I find the part number and model of my Whirlpool freezer?

You can find the part number and model of your Whirlpool freezer by looking at the label inside your freezer door or on your owner’s manual. The part number of your LED module should start with W followed by 9 digits.

• How do I dispose of my old LED module?

You should dispose of your old LED module according to your local regulations for electronic waste. Do not throw it in the trash or recycle bin, as it might contain hazardous materials.

Conclusion

Replacing the LED light in your Whirlpool freezer is not as hard as it seems. You just need to unplug your freezer, remove the light shield, disconnect the wires, replace the LED module, reconnect the wires, and reinstall the light shield. This should make your freezer bright and functional again.